Connecting to wifi network through command line:
In this tutorial we will see how to Connect to wifi network through command.
Lots of people like graphical utilities for managing their computers, but plenty don’t too. If you prefer command line utilities, managing WiFi can be a real pain. Well, it doesn’t have to be.
wpa_supplicant can be used as a command line utility. You can actually set it up easily with a simple configuration file.
Scan For Your Network
If you already know your network information, you can skip this step. If not, its a good way to figure out some info about the network you’re connecting to.
wpa_supplicant comes with a tool called
wpa_cli which provides a command line interface to manage your WiFi connections. You can actually use it to set up everything, but setting up a configuration file seems a bit easier.
wpa_cli with root privileges, then scan for networks.
# wpa_cli > scan
The scan will take a couple of minutes, and show you the networks in your area. Notate the one you want to connect to. Type
quit to exit.
Generate a Block and Encrypt Your Password
There’s an even more convenient utility that you can use to begin setting up your configuration file. It takes the name of your network and the password and creates a file with a configuration block for that network with the password encrypted, so it’s not stored in plain text.
# wpa_passphrase networkname password > /etc/wpa_supplicant/wpa_supplicant.conf
Tailor Your Configuration
Now, you have a configuration file located at
/etc/wpa_supplicant/wpa_supplicant.conf. It’s not much, just the network block with your network name and password, but you can build it out from there.
Your file up in your favorite editor, and start by deleting the commented out password line. Then, add the following line to the top of the configuration.
It just lets users in the
wheel group manage wpa_supplicant. It can be convenient.
Add the rest of this to the network block itself.
If you’re connecting to a hidden network, you can add the following line to tell wpa_supplicant to scan it first.
Next, set the protocol and key management settings. These settings correspond to WPA2.
The group and pairwise settings tell wpa_supplicant if you’re using CCMP, TKIP, or both. For best security, you should only be using CCMP.
Finally, set the priority of the network. Higher values will connect first.
Save your configuration and restart wpa_supplicant for the changes to take effect.
Certainly, this method isn’t the best for configuring wireless networks on-the-fly, but it works very well for the networks that you connect to on a regular basis.